|building = entrance|
|To mark the location of a building entrance.|
|Used on these elements|
|Tools for this tag|
The tag building=entrance was used on nodes along and on the building outline to mark the locations of entrances, i.e. doors.
This tag conflicts with building=* because an entrance is not a building, but part of a building. entrance=* has been introduced as a replacement (see Proposed features/entrance). building=entrance currently coexists with entrance=*, while entrance=* is now used much more, see taginfo comparison.
In some countries each entrance is considered to have distinct housenumber, in others a housenumber is property of the whole building.
- Where each entrance of a single building has a unique house number, tag the addr:housenumber=* on that node; for a reasoning, see the SotM session presentation.
- Elsewhere an entrance may have a unique identifier in addition to the house number; you should add that on the entrance node.
Some ways to improve the location of the entrances
Although the GPS accuracy is limited, you can get reasonable results by visually approximating how far along the wall the entrance is. That is, is the door exactly at the halfway point, or one third of the wall length from either end? You can also visualize any passenger car of known length along the wall and count the distance accordingly. At least JOSM will show you the distance from any selected node to aid positioning the new node a known distance from the selected corner.
Another method is to approach the building straight to the entrance to have a track that you can extend until it meets the buidling outline.
When combined with meticulously positioned aerial images the result is better than a single GPS measurement at the door could provide. Remember to align the nodes of a straight wall in a line (in JOSM: Tools - Align Nodes in Line), but also remember that not all buildings that appear to be straigt are really straight.
For an apartments building flat numbers can be specified for every building=entrance node. Use addr:flats=NN-MM with the interval, for example, addr:flats=9-17. If the entrance is for only one flat, use a single number: addr:flats=14.
If the numbering is not sequential, separate intervals with a semicolon: addr:flats=3-7;10;14;16-18.
- addr=* for adding house numbers, the current way for that is the Karlsruhe Schema
- entrance=* as another way of tagging entrances
No wide used map layer shows nodes tagged with building=entrance.