Key:incline

From OpenStreetMap Wiki
Jump to navigation Jump to search
Public-images-osm logo.svg incline
Incline17.jpg
Description
Incline steepness Show/edit corresponding data item.
Group: properties
Used on these elements
may be used on nodesmay be used on waysshould not be used on areasshould not be used on relations (except multipolygon relations)
Documented values: 3
Status: de factoPage for proposal

Indicates a way's grade, slope, or incline. In the case of roads, there is often a warning sign along the road.

Values

The incline is most commonly given either as

  • the gradient; the ratio of vertical to horizontal change as a percentage (numeric with postfixed percentage symbol, %); e.g., incline=15%. This is calculated as rise h over run d by the formula 100%×hd.
  • the angle of inclination from the horizontal (numeric with postfixed degree symbol, °); e.g., incline=10°. This is preferred only where widely in use.

As one moves forward on a way, a positive incline gets higher, and a negative incline gets lower.

If the incline is unknown, it can be specified simply as incline=up or incline=down. See below for how to use these.

Changing inclines or bridges

Attribute incline=up/downshow an up and down incline, like for a foot bridge (it can be problematic for bicycles or pedestrians...)

Usage

On ways

Split the way at the ends of the steep section and add a tag incline=value% on the way with values as given above. The value should be given for the practical maximum incline on the steep section (i.e., the maximum incline that a vehicle/primary user could achieve), and not for the average incline between the nodes. See Talk:Key:incline.

Most occurrences of this tag are on steps (highway=steps), usually tagged with incline=up or incline=down.

On nodes

The use of this tag has limited (if any) usage, as nodes do not have any direction. It may be used only on nodes that are used by a single way, but it does not mean that this is the inclination of the whole way.

To avoid problems that could occur when the node is shared by an intersection of ways, you should tag instead a segment-way between two nodes where the incline angle is effectively measurable.

Extremely short inclined segments (under about 1 meter on ways for vehicles, or below 10 centimetres for footways usable by wheelchairs) generally don't need to be tagged as they are not really significant barriers if the incline rate remains below about 50% (otherwise they are effectively "steps").

Estimates

In case you don't know the exact value you can:

Relationship between gradient and angle

Values can be converted as follows:

  • gradient in %› = tan(‹angle in °›) × 100% = tan(‹angle in °› × πc / 180°) × 100%
  • angle in °› = arctan(‹gradient in %› / 100%) = arctan(‹gradient in % / 100%) × 180° / πc

The rate of change of the gradient with respect to the inclination is not constant. E.g., 10° is 17.63%, and 30° is 57.73% (not 52.89%).

Pente-Slope --Degres-Ratio V1.jpg

Common and extreme inclines

Common values for this tag are in the range −25% to 25% on roads. Ways with a steepness of under 10% are seldom signposted, except on motorways in mountainous regions (for sections longer than about 500 meters where an acceleration not controlled by braking may expose to danger, notably in curves or with other slower vehicles or with people walking along the road), but inclines of over 20% are rare and pure visual estimation of steepness often results in too big values.

Maximum known inclines on public streets is 37% at w:Canton Avenue - the steepest officially recorded public street in the United States. Standing upright in an incline of 52% (found in downhill pistes) can already be tricky, and not only because the shoes start to slip. The steepest groomed ski pistes are around 100% (i.e., Piste de l'Aigle in Zinal, Switzerland, around 100%, or Harakiri in Mayrhofen, Austria, at 85%). Off-piste skiing takes place on even steeper terrain for experts only.

Long inclines in mountains are considered steep for bicycles when they reach 15% for a significant length. In sports competitions, they are challenging and frequently assigned a "category" according to the total length of steep incline. There's no international standard for this category, each competition decides the category and assigns specific points for the sportive challenge, and this categorization may change over time at each competition event; however the categorization is for a long route that include sections with variable inclines requiring more than a few minutes of efforts. So there's no permanent signs for these categories except during these competition events.

On the opposite, the categorisation of long steep inclines on pistes open for skiing is signed permanently with conventional colours marking their difficulty. These colours (typically from green to blue, red, and black in Europe) are tagged separately. See piste:difficulty=*.

One stated recommended maximum transverse incline for a footway usable in a wheelchair has been 2.5%.[1]

incline:across=* has been suggested in Proposed features/incline:across.

Hops

incline=up/down has some use for marking ways without clear overall incline but with many up/down hops. Some people would prefer it to be a separate tag but there is no any known used alternative or clear replacement or clear deprecation of that value[2]

This use was confirmed by asking all people who used this specific tag[3]

There is also opposition to treating this value seriously, see https://wiki.openstreetmap.org/w/index.php?title=Key:incline&diff=2410960&oldid=2404953 and https://wiki.openstreetmap.org/w/index.php?title=User_talk:Tordanik&oldid=2411029#incline

It was not included in Proposed features/incline up down

Tagging based on traffic signs

An easy derivation of the data is possible using the source of existing traffic signs (traffic_sign=*) for slope warning, see table:

Sign photo Tagging
Vienna Convention road sign Aa-3c-V1.svg incline=up
Vienna Convention road sign Aa-2c-V1.svg incline=down
Vienna Convention road sign Aa-3a-V1-1.svg incline=10%
Vienna Convention road sign Aa-2a-V1-1.svg incline=-10%

For other warning traffic signs, their impact is mainly tagged as hazard=*.

Possible tagging mistakes

If you know places with this tag, verify if it could be tagged with another tag.
Automated edits are strongly discouraged unless you really know what you are doing!
If you know places with this tag, verify if it could be tagged with another tag.
Automated edits are strongly discouraged unless you really know what you are doing!
If you know places with this tag, verify if it could be tagged with another tag.
Automated edits are strongly discouraged unless you really know what you are doing!
If you know places with this tag, verify if it could be tagged with another tag.
Automated edits are strongly discouraged unless you really know what you are doing!
If you know places with this tag, verify if it could be tagged with another tag.
Automated edits are strongly discouraged unless you really know what you are doing!
If you know places with this tag, verify if it could be tagged with another tag.
Automated edits are strongly discouraged unless you really know what you are doing!

See also

References